Furniture Progress

Just a very quick update for now,  the vast majority of the furniture construction is now done.

Just a worktop to shape and fit, a small rear shelf to add, and some holes to cut for sockets, and the Sargent controller etc.

I'd love to hear your comments on the work so far.

Furniture Update

So yet again it's been a while since my last post, but this time I've got something to show for the time.

The main cupboard / wardrobe, with the tambour door fitted.

The lower shelf isn't secure in yet, as I need to make a trapdoor in it to access the Leisure battery.

Central  cupboard finished which will house the water carrier and gas cylinder.  Also behind the door will be a small concealed cutlery drawer.

The 'ikkle drawer!

Next up will be fitting and securing the furniture in place, then starting to wire up the electrics.

Start of final construction

After finishing the mock furniture, it's time to start the proper units.  I have opted for a driftwood units, topped with a black granite effect worktop.  All constructed with 15mm lightweight ply.

I've started on the large unit at the back, and the unit to house the fridge and the gas/water.  I'll get some more photos as the build progresses.

Lots to be getting on with over the next few days, I'll try and keep this updated as much as possible.

New stoppers

In a break from the usual blog posts about converting the van, this one is about basic maintenance.

The discs were looking a bit crusty on the front and back, so its time to replace the lot.  Ok crusty might be an understatement, these things were knackered!!

Only one small snag, and that was the NSR calliper was seized, so that's been replaced,

New stoppers all finished!  Now to get back on with the conversion.

Mock Design Complete

I've finally finished mocking the interior for the van.  I've changed a few bits around and chnaged my mind countless times, but I've now finally settled on a configuration that works for me.  I'll let the pictures do the talking.

Now to work out a small cutlery draw

Mock Layout

Ok, so with the large gap between posts, I've been busy planning the layout.  I decided to mock the units out of basic 12mm ply.  This has allowed me to easily change the layout and positions of stuff.

Granted I had to buy 5 sheets of ply to do this, which cost around £100, but I think it was well worth it, and I can use the panels as templates when I make the furniture out of lightweight ply.

Either way, im a log way of being finished, but here is a quick look at my progress so far.

I've still got the rear contour cut to do, but the cardboard template is made for it.  

One issue I do yet still need to work out, is where I can have a drawer.

Im also debating where to situate the 907 gas cylinder, so if you've any thoughts on this, I'd love to hear them

Great News!

Apologies for the lack of updates, It's been a hectic few weeks.

I've found out I'm becoming a Dad for the first time, so lots of exciting times ahead.

Also after 6 years I finally got down on one knee, and asked my better half to marry me. Amazingly she said yes!

Now to get cracking with the van before the little'un arrives.